Download 2007 - 2005 - Aries Spas

Transcript
Aries Spas • User Manual
or replace if necessary. Make sure the O-Ring is seated properly in the
groove of the lid. Replace lid, making sure that it doesn't cross-thread,
and tighten it sufficiently.
Water in spa is “ugly” or smells bad
Water used to fill the spa was dirty, or water in the piping
of the spa was dirty.
It can take your spa a day or two to clear up when initially filled. Make
sure your spa is in the “24 Hour” Mode and running continuously. In
extreme cases, especially when a spa has been filled with well water, it
may be necessary to drain and refill the spa, using filtered water.
Water is not being circulated sufficiently.
Make sure your spa is in the “24 Hour” Mode and running continuously, so that the Ozonator (if so equipped) or chemicals will be properly
mixed in the water. We recommend running the Circulating Pump
continuously for maximum circulation and filtration.
Filter Cartridge is clogged with body oils or other debris, or
filter is damaged
Thoroughly clean the filter, as described in “Cleaning Your Filter”. If it
still seems heavily embedded, or is damaged, replace it. If the filter is
difficult to clean and is over a year old, it is probably time to replace it.
The water has not been chemically treated or there is a
chemical imbalance.
See the section on water treatment elsewhere in this manual.
If spa is equipped with Ozone Generator or other nonchemical sanitizer, it is not operating properly.
Make sure the device is plugged in tightly. If it has a fuse, check to see
that the fuse has not blown, and replace if necessary.
Verify that a blue or green light is being omitted from the Ozone Generator. Also, make sure that bubbles are coming from one or both ozone
jets located near the light fitting.
Make sure your spa is in the “24 Hour” Mode and running continu-
Page 32