Download Wind Generator Manual

Battery is not fully charged:
Possible cause
Test
Solution
Old, damaged battery
deficient
Test battery status and
liquid of every battery
Fuse gone
Check fuse
Charge controller wrongly
installed
Charge controller stopswitch is in position
“STOP”
Deficient generator
Check in line with manual
Replace battery,
refill destilled water (not
necessary for gel- or AGMbattery)
Replace fuse,
find cause of deficiences
Correct installation
Switch stop switch in
position “RUN”
Observe manual
instructions
Check AC voltage,
AC screw terminals
Check all 3 AC cables after
disconnecting from charge
controller as to short circuit
Repair customer service /
replacement
Deficient charge controller, Check adjustments
mix up of polarity
according to instructions
13