Download 5000-6.2.10, Pyramid Integrator, Installation Manual

Chapter 12
Configuring Hardware for the MicroVAX
Information Processors
See Table 12.B for test numbers to use for testing the devices.
3.
View the results of the self test.
If the test was:
You will see the selftest number followed by:
Successful
...
For example, a successful selftest of the floating
point unit looks like this:
9...
Not successful
?.. and the message 84 FAIL.
For example, an unsuccessful selftest of the
floating point unit looks like this:
9?..
84 FAIL
To find out what the error is, display the system configuration table.
For more information, go to the next section.
Display SelfTest Error Codes in System Configuration Table
To see the error codes for all tested devices, bring up the system
configuration table. This table gets updated every time the MicroVAX
Information Processor is powered up or a self-test is run.
1.
At the console prompt, enter: TEST 50
You will see the system configuration table looks similar to this:
KA42-IN V2.1
ID 00-00-BC-01-01-C7
CLK
0000.0001
NVR
0000.0001
DZ
0000.4001 V0.1
00000001 00000001 00000001 00004001 0000000 00000000
MEM
0002.0001
00200000 000000002
MM
0000.0001
FP
0000.0001
IT
0000.0001
SCSI-A
2828.0001
1000.0001 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05
SCSI-B
1C1C.0001
1000.0001 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF05
SYS
0000.0001
BPI
0000.0005 V0.7
NI
0000.0001
12-7