Download Manual

Appendix V: Seasave Remote for Remote Display and Bottle Firing
11. In Seasave Remote's Bottle Fire menu, click Bottle Fire Control. In the
Bottle Fire dialog box, click Connect. The Status bar should show that
you are connected to the bottle fire client (“Connected to . . . on ports . . .
and . . .”); you can now fire bottles from Seasave Remote.
Note:
When SEASAVE receives a bottle fired
confirmation from a water sampler, its
response to remote bottle firing is
identical to bottle firing from within the
software: it writes bottle fire data to a
file or sets a bottle confirm bit in the
data file, as applicable to the
equipment used. See Firing Bottles by
Command from SEASAVE above.
12. In Seasave Remote’s Remote Bottle Fire window, click Fire Bottle when
desired.
When SEASAVE receives a bottle fired confirmation from a water sampler,
it increments the #Fired and shows the bottle number that was fired in the
Bottle Firing Sequence box.
When Seasave Remote receives a bottle fired confirmation from
SEASAVE, it increments the #Fired, and shows the bottle number that
was fired in the Sequence box.
13. When you are done:
A. To end TCP/IP transmission of data or access to a shared file In Seasave Remote's Data menu, click Disconnect.
B. To end transmission of bottle fire commands and responses In Seasave Remote's Bottle Fire dialog, click Disconnect.
OR
In SEASAVE’s Remote Fire Bottle Fire dialog, click Disconnect.
14. In SEASAVE, stop real-time data acquisition.
122