Download User`s Manual

Transcript
Caller ID Telephone Production Tester
Script Language
JAPAN.SCR
** This script simulates the Calling Line Identification (CLI) signal
** defined in NTT's Specifications. Critical timing parameters and
** signal levels are controllable.
** Initialization
MODEM V23
LEVEL 20
SNR 30
RingLevel 55
RingFreq 20
* Selects V23 FSK Modem Type
* Sets the FSK Signal Level to -20 dBm
* Sets the Signal-to-Noise Ratio to 30 dB
* Sets the Ring Level to 55 Vrms
* Sets the Ring Frequency to 20 Hz
** Begin Caller ID Sequence
Polarity Reverse
Delay 150
* Reverses the line polarity
* Delay for 150 mS (should be >=100 mS)
Ring 500
Delay 500
Ring 500
Delay 500
Ring 500
Delay 500
Ring 500
Delay 500
Ring 500
Delay 500
Ring 500
WaitforOffHook 1000
* Ring for 500 mS - CPE Activation Ringing (CAR)
* Delay for 500 mS
* Wait for Off-Hook for 1000 mS - Should be already off-hook
** Data Transmission
Delay 200
* Delay for 200 mS before commencing data transmission
Carrier ON
* Turn carrier ON
Delay 50
* Delay for 50 mS so that carrier is ON for that period
PARITY EVEN
* Set parity
SEND <10><01><07><10><02><40><0C><02><0A>0335092111<10><03>
* Send Caller ID data
PARITY NONE
* Set parity
SEND <8A><D3>
* Send 16-bit Checksum (CRC-CCITT) from header <07> to ETX
<03>
Delay 20
* Delay for 20 mS
Page
164