Download W - Brico Sergio

Setup & Adjustments...
Adjusting the Riving Knife
Raise the saw blade to its highest point and remove the saw blade guard. Remove the four
hex screws and place carefully aside, remove the table insert. Using the spanner provided
loosen the riving knife and adjust until the tip of the riving knife is 3mm away from the saw
blade & re-tighten. (See fig 54).
NOTE: Check that the riving knife is parallel to the saw blade by placing the fence
up against them. (See fig 55).
Z
Fig 54
Fig 55
Adjusting the Fence to the Blade
The fence assembly must be parallel to the saw blade for producing accurate cuts. Firstly
loosen the fence clamp assembly knob (N), slide the fence until it reads “ZERO” on the
table support arm scale (X). (See figs 56 & 57).
Fig 57
Fig 56
Z
X
“Zero”
NOTE: Use the ‘T’ slot to the right side of the saw blade as a reference to check the fence is
parallel. (See figs 58 & 59). Regularly check the fence is parallel to ensure a perfect cut.
Fig 58
“T” Slot
Fig 59
Continues on next page....
22