Download user`s guide

W I N P I L O T
U S E R ’ S
G U I D E
Mode selects when the vario sound changes from vario
to speed to fly.
Switch Style when set to External it will
use the information from an external switch which you
must have installed somewhere in the cockpit.
In the On circling mode it will change to vario when the
glider is circling while it will be in Speed to
fly mode while cruising. Auto speed mode will switch to
speed to fly mode when the airspeed
becomes greater than the Spd. value on this same panel.
Switch style allows you to "invert" the switch operation
through the software. Taster option will
change the modes each time the taster is pressed.
TAB allows you to select how deep the silent are is (this
is an area around zero where speed to fly
indication will not beep).
Vario Filters affects sensitivity of the vario. The higher
the number, the slower vario needle and audio
signal respond. Default = 1 sec
TE Filter selects the filter for Total Energy. The higher
the number, the longer it takes for the vario to show the
change in Total energy altitude of the glider. .1 to 2.0
seconds, default is 1.5
Smart filter is a dynamic filter and controls the rate at
which the vario indication moves. Higher
number is slower, more filtered. (see LX1600
documentation for more on this)
TE Level allows you to compensate for inaccuracies in
static pressure/TE tubes. See the LX 1600
manual (chapter 3.2 - Pneumatic Connection) about how
to connect the tubes in order to have electronic
compensation (it is different than the tubing when
connected to TE pressure compensation). If using a TE
Probe Set to 0. No adjustment is possible. If using
electronic TE then see the LX1600 manual for setup.
100% is default for Electronic TE Compensation.
Audio panel is at the second settings page - LX1600(2).
Style lets you choose between the following types of
variometer sounds:
Lin/neg = The sound changes in linear correlation to the
vario reading. It is intermittent at negative
vario values.
Lin/pos = The sound changes in linear correlation to the
vario reading. It is intermittent at
positivevario values. This is the default setting.
Linear = The sound changes in linear correlation to the
Page 73
0 5 / 2 0 / 0 5