Download Roland ZCL-540 Users Manual

2-1 Before Installing
Checking the Included Items
The following items are included with the unit. Make sure they are all present and accounted for.
Drive unit
Tailstock
Base plates x2 (*1)
Live center
Center drill
Y-origin sensor
Z-origin sensor
Spacer (*1)
Origin-detection pin
(diameter 6 mm)
Cap screws
(M8 x 20 mm) x8 (*2)
Cap screws
(M4 x 30 mm) x3 (*1)
Cap screws
(M4 x 15 mm) x3 (*3)
T-slot nuts x2
Hexagonal wrenches
(6 mm, 3 mm)
Retaining band
User's Manual (this manual)
*1 Not used on machines installed with a T-slot table.
*2 On machines installed with a T-slot table, only two are used.
*3 Not used on machines installed with the standard table.
24
Chapter 2 Installation