Download Startup & Maintenance Guide

3-7 Pausing and Stopping Cutting
Ž
Use
Press
or
to select “CONT.”
to confirm.
The cutter returns to the location where paused, and cutting resumes.
Selecting “VIEW” or “CONT.” while the front cover is open makes the message
shown in the figure below appear. After three seconds the message disappears
and the screen returns to the original menu. Close the front cover, then redo
the selection of the operation item.
Important!
Before opening the front cover while operation is paused, first make sure that rotation of the spindle is stopped. For safety,
opening the front cover while the spindle is turning makes the machine perform an emergency stop. Be sure to note that if
this happens, it’s necessary to quit the operation and start over from the beginning.
F P. 55, “Emergency Stop Due to Opening or Closing the Front Cover”
Other operations possible while paused
 Starting or stopping spindle rotation
F P. 66, “Starting and Stopping Spindle Rotation”
 Changing the spindle speed
F P. 67, “Adjusting the Spindle Speed”
 Changing the feed rate of the cutter
F EGX-360 Engraving Guide
Chapter 3 Basic Operation
69