Download CipherLab 1266 User Manual
Transcript
Chapter 1 Using the Barcode Scanner The scanning won't stop until (1) a barcode is decoded, and (2) the preset timeout expires. Note: By default, the scan mode of 1000 and 1090+ is set to Auto Off mode. 1.4.8 AUTO POWER OFF MODE The scanner will start scanning once the trigger is pressed. The scanning won't stop until the pre-set timeout expires, and, the preset timeout period re-counts after each successful decoding. 1.5 AUTO-SENSE MODE (1100 ONLY) This mode is only available for 1100 when you want to seat it in the Auto-Sense Stand. When you enable this mode, it will force the scanner to apply Laser mode as the scan mode. However, it works slightly different from the original Laser mode. Now the scanner will be scanning as long as it is seated in the Auto-Sense Stand. Whenever a barcode is brought within range, the scanner will be able to decode it. When you disable this mode later, the scan mode remains unchanged. If Laser mode is not desired, proceed to select a scan mode best suits your application. Note: By default, Auto-Sense Stand mode is disabled. 1.6 SCANNER TIME-OUT You can limit the maximum scanning time interval for the following scan modes – Laser mode Auto Off mode Auto Power Off mode Note: By default, the scanner time-out is set to 10 seconds. 1.7 DELAY BETWEEN RE-READ This is also referred to as the “Blocking Time”, which is used to prevent the scanner from accidentally reading the same barcode twice when the scan mode is set to any of the following – Continuous mode Momentary mode Alternate mode Auto Power Off mode Note: By default, the blocking time is set to 400 milliseconds. 19