Download RoVa3D User Manual

Transcript
4.3.
4.4.
4.5.
Level 2 Service ..........................................................................................80
4.3.1.
Refresh bed printing surface ....................................................................................... 80
4.3.2.
Change nozzles ........................................................................................................... 80
4.3.3.
Replace Belts .............................................................................................................. 81
4.3.4.
Clean fans ................................................................................................................... 84
4.3.5.
Service the smooth shafts ........................................................................................... 85
Level 3 Service ..........................................................................................86
4.4.1.
Replace Ball Bearings ................................................................................................. 86
4.4.2.
Replace Linear Bearings ............................................................................................. 88
4.4.3.
Replace filament feed tube .................................................................................... 90
4.4.4.
Replace liquid coolant ................................................................................................. 90
Level 4 Service ..........................................................................................93
4.5.1.
Replace hot-end heater cartridge ................................................................................ 93
4.5.2.
Replace print bed heating element .............................................................................. 93
4.5.3.
Replace the smooth shafts .......................................................................................... 94
5. Troubleshooting .................................................................................................................................... 96
5.1.
First layer won‟t stick ............................................................................ 97
5.2.
Cleaning extruder filament drive wheel ............................................................99
5.3.
Clearing Extruder filament guide holes .............................................................99
5.4.
Clearing a Jammed Hotend ................................................................... 100
5.5.
Clearing a jammed nozzle ........................................................................... 100
5.6.
Repairing a popped filament feed tube ........................................................... 101
5.7.
Printer won‟t home X/Y/Z ...................................................................... 101
5.8.
Bed won‟t heat above X(°C) ................................................................... 102
5.9.
Nozzle won‟t heat above X(°C) ..................................................................... 103
5.10.
Feedtube end broken off inside quick release ................................................... 104
5.11.
If all else fails ......................................................................................... 104
Special thanks to Tim Hedstrom, Joan Touzet, and all of our forum users and Kickstarter
backers who have contributed to the body of knowledge incorporated into this manual!
ordsolutions.com