Download RoVa3D User Manual
Transcript
4.3. 4.4. 4.5. Level 2 Service ..........................................................................................80 4.3.1. Refresh bed printing surface ....................................................................................... 80 4.3.2. Change nozzles ........................................................................................................... 80 4.3.3. Replace Belts .............................................................................................................. 81 4.3.4. Clean fans ................................................................................................................... 84 4.3.5. Service the smooth shafts ........................................................................................... 85 Level 3 Service ..........................................................................................86 4.4.1. Replace Ball Bearings ................................................................................................. 86 4.4.2. Replace Linear Bearings ............................................................................................. 88 4.4.3. Replace filament feed tube .................................................................................... 90 4.4.4. Replace liquid coolant ................................................................................................. 90 Level 4 Service ..........................................................................................93 4.5.1. Replace hot-end heater cartridge ................................................................................ 93 4.5.2. Replace print bed heating element .............................................................................. 93 4.5.3. Replace the smooth shafts .......................................................................................... 94 5. Troubleshooting .................................................................................................................................... 96 5.1. First layer won‟t stick ............................................................................ 97 5.2. Cleaning extruder filament drive wheel ............................................................99 5.3. Clearing Extruder filament guide holes .............................................................99 5.4. Clearing a Jammed Hotend ................................................................... 100 5.5. Clearing a jammed nozzle ........................................................................... 100 5.6. Repairing a popped filament feed tube ........................................................... 101 5.7. Printer won‟t home X/Y/Z ...................................................................... 101 5.8. Bed won‟t heat above X(°C) ................................................................... 102 5.9. Nozzle won‟t heat above X(°C) ..................................................................... 103 5.10. Feedtube end broken off inside quick release ................................................... 104 5.11. If all else fails ......................................................................................... 104 Special thanks to Tim Hedstrom, Joan Touzet, and all of our forum users and Kickstarter backers who have contributed to the body of knowledge incorporated into this manual! ordsolutions.com