Download User manual - Projector Central

3. Installation
3.4 Powering On/Off the Projector
3.4.1 Powering On the Projector
Procedure:
1.Ensure that the power cord and signal cable are securely connected. Power on the switch
Status LED is solid red.
1
and wait until the
2.Turn on the projector by pressing “ ” on the remote control or the control panel. The Status LED is off.
The startup screen displays in approximately 10 seconds.
2
3.Turn on your source. Select an input source by the remote control (HDMI, VGA, DVI or Video).
The projector detects the source you selected and displays the image.
2
Power button
Menu
or
HDMI
Enter
VGA-OUT
VGA-IN
DVI
LAN
RS-232
Status LED
RS-232
12V
OUT
5V
OUT
CVBS
1
Power Switch
IR Receiver
3.4.2 Powering Off the Projector
Procedure:
1.Press “ ” key of on the remote control or the control panel, a message displays on the projector’s screen.
2.Press “ ” key again to confirm, otherwise the message disappears after 5 seconds.
CAUTION: Don’t turn on the projector immediately after entering Standby mode.
PGWX-62L/PGWU-62L/PGWX-62L-K/PGWU-62L-K - - 2015/03/06
21
12V
OUT