Download Workshop Manual - IRIZAR

Aisle Armrest
Disassembling:
1.
Take the screw caps off (1).
2.
Loosen the hexagonal head bolts (2), with the correspondent washer
and nut.
Assembling:
1.
Introduce the bolts (2) in the arm holes adding the washers (3).
2.
Place the armrest in the seat placing the spring washer in the inner side
(4) fixing with 2 nuts.
3.
Tight the bolts.
Armrest gripping cover
Disassembling:
1.
Loose the bolts (2).
Assembling:
1.
Tight the bolts.
BOLTS TORQUE
The bolted unions must be tighten following the toques on the next table since there are no special
remarks to the referred mechanism.
This specifications is applied to hexagonal or cylindrical head bolts and steel nut with friction factor
from 0,12 to 0,14.
The torque is specified combing the metric labeling, wires pitching and quality of each bolt.
136