Download Section II - Rites Ltd.

Appendices
2
Blade Bays
Blade Chassis to accommodate minimum of 8 Full Height
/16 Half Height Hot Plug-gable Blade Servers with Dual I/O
Connectors as well as Power Connectors for Redundancy.
3
Ethernet Switch Modules
2 No.s 10G Ethernet Switching Modules to be provided in
redundant configuration for Connecting to all the blade
servers to external Switch. Configuration should help
minimize the Ethernet Cables and 2 nos of 10/100/1000
Mbps Ethernet switch with minimum 4 uplink ports.
4
I/O Path for all Fabrics
Chassis should have dual I/O connections from every blade
server to help provide maximum uptime
6
Fibre Channel
Module
7
Management Modules
8
Total
No.
of Chassis should support all modules ethernet(1g/10g),
Switch/Bridge
Module infiniband, FC ports in load balancing and failover mode.
Slots
These cards should be on separate PCI based slots in blades.
9
Fan/Blower Modules
Should have
Modules
10
Power Modules
Dual Power Supply to cater power for the blade servers
(redundant). No single point of failure for Power Delivery.
No single fault should take down the entire power bus.
Should have N+N power topologies for higher uptime.
11
Redundancy
Modules
in
Power Chassis should have redundant fans on the power supplies
and should be able to provide reconfiguration of fans and
power supplies without manual intervention
12
CD/Diskette/USB
CD-ROM/DVD-ROM Drive which can be shared among all
the blade servers.
13
Failure Support
Failure warning Support for Blades, bridge/switch modules,
I/O modules, management modules, power modules, blower
modules, media tray
16
System Management
Should support diagnostic features for Blade server,
processor, memory, power supplies, blowers, switch
module, management module
17
System Panel
Colour LED/LCD panel to provide power-on, location, over
temperature, information and system error conditions
18
Support for heterogeneous The chassis should be able to support Blade Servers
Servers
RISC/EPIC/CISC/X-86 (Intel) architecture processors
Switch The Blade Channel SAN Switches. Each SAN Switch
should be minimum 20 Port capable, providing connectivity
to each blade server slot and providing at least 4Gbps
Uplink ports for connectivity to External Storage
Hot swappable management module to communicate with
the system management processor on the Blade Servers
from remote locations.
Redundant and hot swappable blower or fan
73