Download 1305 Adjustable Frequency AC Drive

Transcript
Programming
5-21
Advanced Setup Group (continued)
[Analog Invert]
This parameter enables the inverting function for the 0-10
Volt and 4-20mA analog input signal at TB2.
Parameter # 84
Parameter Type Read & Write
Units Text
Factory Default ‘‘Disabled”
Settings ‘‘Enabled”
‘‘Disabled”
Figure 5.12 Analog Invert
Maximum Input Commands [Minimum Freq]
Minimum Input Commands [Maximum Freq]
Maximum Input Commands [Maximum Freq]
Minimum Input Commands [Minimum Freq]
[Maximum Frequency] '
Disabled
Drive Output
Enabled
[Minimum Frequency] '
y
0V
4 mA
[4-20mA
[4
20mA Loss Sel]
This parameter
p
selects the drives reaction to a loss of a
4 20 A signal
4-20mA
i l when
h the
th active
ti [Frequency
[F
S
Source]] iis
4 20mA Important: The drive output contacts can be
4-20mA.
used to issue an alarm signal by setting [Output 1 Config]
or [Output 2 Config] to “alarm”.
alarm . Important: Loss of signal
is defined as a signal < 3.5 mA or a signal > 20.5 mA.
Parameter # 81
Parameter Type Read & Write
Units Text
y
10 V
20 mA
Factory Default ‘‘Stop/Fault”
Settings ‘‘Stop/Fault”
‘‘Hold/Alarm”
‘‘Max/Alarm”
‘‘Pre1/Alarm”
‘‘Min/Alarm”
Drive Stops and Issues ‘‘Hz Err Fault” (F29)
Drive Maintains Last Output Freq and sets an Alarm bit
Drive Outputs [Maximum Freq] and sets Alarm bit
Drive Outputs [Preset Freq 1] and sets an Alarm bit
Drive Outputs [Minimum Freq] and sets an Alarm bit