Download Dyn-Loc V Quick Start Guide

Power shall NEVER be applied to the Dyn-Loc V during the wiring process.
TORQUE Connector Wiring Options:
Load Cell
Belden 9534 (Item 3 in Cable table)
Pin
Wire
Function
4
Red
Excitation (+10 VDC)
16
Black
Excitation Common
14
Green
Input (+)
1
White
Input (-)
2
Shield
Install a jumper wire between each of the following pairs of pins:
5 – 6, 17 – 18, 3 – 13
In-Line Torque Sensor
Belden 8761 (Item 1 in Cable table)
Pin
Wire
Function
13
Clear
Torque Sensor Input
25
Black
Torque Sensor Input Common
12
Shield
NOTE: Additional hardware may be required if using an In-Line torque sensor. If the torque sensor was
provided by Dyne Systems, reference the associated system drawings; else, reference the torque sensor
manufacturer’s documentation.
Setup Parameters:
The torque transducer must be properly configured in order to produce accurate readings. Power-up the DynLoc V. Then press the “SETUP” button to access all configuration parameters. Navigate to the following folder
which contains all torque configuration parameters:
“\\Dyn-Loc V\Control Variables\Torque”
For the installed torque transducer, set the “Transducer Type” (Load Cell or Torque Sensor) as needed. This
setting determines exactly which of the remaining settings need to be configured.
For a load cell, get the full scale value (and units) and the sensitivity (MvV) from the load cell datasheet. Enter
these values into the “Load Cell Full Scale Value”, “Setup Force Units”, and “Load Cell MvV” configuration
parameters.
NOTE: The units of the final torque reading can be different from the units used now during setup.
Dyn-Loc V Quick Start Guide
© Dyne Systems, Inc.
Rev 1.0
Page 5 of 10