Download User Manual

8. Managing Adapters and Ports
FC/FCoE
3. Click Configure DCB. The Configure DCB dialog box appears.
4. Configure the settings you want and click OK.
Note: An error message is displayed if you try to configure more priority groups
than the adapter supports. The “Max Configurable PGs” field in the ETS
Priority Groups area shows the number of priority groups supported by the
adapter.
Figure 8-32 Configure DCB Dialog Box for FCoE Adapter Ports (DCBX Enabled)
Configure DCB Dialog Box Field Definitions
DCBX Settings Area



Enabled – DCBX can be enabled or disabled. With DCBX enabled, the
configured values are used only if the switch does not provide them. With
DCBX disabled, the configured values are used.
DCBX Mode – The DCBX mode can be set to CEE or Cisco-Intel-Nuova (CIN).
Changes to the DCBX mode require a reboot of the host.
Operating Version – Operating version of the DCBX protocol. The system
adjusts as needed to operate at the highest version supported by both link
partners. This setting cannot be changed.
OneCommand™ Manager Application
P009402-01A Rev. A
128