Download User Manual

11. Configuring Boot from an FC SAN
Configuring Advanced Settings (Boot from SAN)

interval scans the loop to discover this device. This default setting is None (0
msec). Set to one of the following:

None (default)

50 ms

100 ms

200 ms
Type the Default AL_PA number – It has a range of 00-EF (default=0). Changes
the AL_PA (Arbitrated Loop Physical Address) of the selected adapter. (Not
available for OneConnect adapters.)
EFIBoot Advanced Adapter Settings Dialog Box
Use the EFIBoot Advanced Adapter Settings dialog box to configure the advanced
settings for the selected EFIBoot adapter.
Figure 11-4 EFIBoot Advanced Adapter Settings Dialog Box
EFIBoot Advanced Adapter Settings Field Definitions


Device Path – Makes the Fibre driver appear as a SCSI driver.

Fibre (default)

SCSI
Boot Target Scan – This option is available only if none of the eight boot entries
are configured to boot via DID or WWPN.

NVRAM Targets (default) – Discovers only LUNs that are saved to the
adapter Non-Volatile Random Access Memory (NVRAM).

Discovered Targets – Discovers all devices that are attached to the FC port.
Discovery can take a long time on large SANs.
OneCommand™ Manager Application
P009402-01A Rev. A
201