Download AFE Controller User`s Manual

Using the Downloader Utility
Once the download is complete, the Downloader Utility remains connected to the target. At
this point the user may download another image, or press the “Jump to Flash” button to start
executing the application stored in FLASH memory. Closing the GUI does not cause the control
board to automatically jump to FLASH – the user must either use the “Jump to Flash” button or
cycle power on the control board in order to start executing the FLASH image.
If an error is detected during programming, the Downloader Utility will automatically initiate a
Clear Memory command to wipe the target of any partial image. The user should take special
care if this happens while updating the Bootloader itself as it may be possible that the
Bootloader is no longer programmed into the EEPROM. The user should NOT cycle power to the
control board until a successful programming attempt has been completed.
Publication UM-0015
7