Download TRP-C32 User`s Manual

to the change. Please check hardware switch or server properties page to see if the serial port
mode of the port1 is set to console. Please change it to other mode then its parameter can be
changed.
Q: Why the parameters in the web console are different than those in the server properties of
management utility?
A: The edited parameters in the web console only take effect after reset TRP-C32. Web console
show the edited configuration while in the management utility show the running configuration.
That is why they might appear differently it is not recommended to edit server's configuration
using two different tools at the same time. Because all change could be over-written by other
method.
31