Download OMRON - Microptic S.L.

Transcript
Index
alarm 2 type, 154
alarm 3 assignment, 180
alarm 3 hysteresis, 163
alarm 3 latch, 167
alarm 3 OFF delay, 172
alarm 3 ON delay, 171
alarm 3 open in alarm, 162
alarm 3 type, 154
alarm SP selection, 181
alarm value 1, 124
alarm value 2, 125
alarm value 3, 125
alarm value lower limit 1, 126
alarm value lower limit 2, 126
alarm value lower limit 3, 127
alarm value upper limit 1, 126
alarm value upper limit 2, 126
alarm value upper limit 3, 127
alpha, 165
AT execute/cancel, 131
auto/manual select addition, 173
auto/manual switch, 120
automatic display return time, 167
character select, 180
cold junction compensation method, 168
communications baud rate, 182
communications data length, 182
communications parity, 182
communications stop bits, 182
communications Unit No., 182
communications writing, 131
control output 1 assignment, 177
control output 2 assignment, 178
control period (cool), 151
control period (heat), 151
cooling coefficient, 139
dead band, 139
decimal point, 148
derivative time, 138
direct/reverse operation, 152
event input assignment 1, 160
event input assignment 2, 160
HB ON/OFF, 163
heater burnout detection 1, 134
heater burnout detection 2, 134
heater burnout hysteresis, 164
heater burnout latch, 164
heater current 1 value monitor, 121, 132
heater current 2 value monitor, 122, 132
HS alarm 1, 135
HS alarm 2, 135
HS alarm latch, 175
228
hysteresis (cooling), 140
hysteresis (heating), 140
initial setting/communications protect, 116
input digital filter, 166
input error output, 168
input shift type, 172
input type, 146
integral time, 138
LBA band, 177
LBA detection time, 176
LBA level, 176
leakage current 1 monitor, 122, 133
leakage current 2 monitor, 123, 133
linear current output, 156
lower-limit temperature input shift value, 137
manual reset value, 140
MB command logic switching, 169
move to advanced function setting level, 156
move to calibration level, 181
move to protect level, 116
move to protect level time, 168
multi-SP set point setting, 120
multi-SP uses, 160
MV (manual MV), 144
MV at PV error, 142
MV at stop, 142
MV at stop and error addition, 173
MV display, 166
MV lower limit, 143
MV monitor (cooling), 128
MV monitor (heating), 127
MV upper limit, 143
number of multi-SP uses, 159
operation/adjustment protect, 116
parameter initialization, 158
parameter mask enable, 117
password to move to protect level, 117
PID ON/OFF, 149
process value, 119
process value/set point, 120
program pattern, 151
program start, 123
proportional band, 138
protocol setting, 182
PV change color, 169
PV stable band, 170
PV/MV (manual MV), 144
RT, 174
RUN/STOP, 124
scaling lower limit, 148
scaling upper limit, 148
selecting, 12