Download User Manual - Motortronics

Transcript
VCM Installation and Operations Manual
17.0 Keypad Key Functions and Navigation
The VCM keypad, provides all the necessary functions to allow full control of the VCM inverter. The keypad has
membrane type keys and a 7 - segment 4 - digit LED display. Also located on the keypad is a potentiometer that can
be used to control inverter output frequency when selected as the control source. A remote keypad is available as an
option, and is covered more in detail in the Option Modules Sec. 20.0.
17.1 VCM Keypad
4 digit 7 segment
LED display
LED indicators
LED indicators
Output frequency
control potentiometer
(when selected)
Membrane keys
Fig. 17.1 VCM Keypad
17.2 Keypad LED Functions
Table 17.1
LED
STATUS
OFF
SEQ (Sequence
ON
OFF
FRQ (Frequency)
ON
*FWD (Forward)
REV (Reverse)
FUN (Function)
*Hz/RPM
ON
Flashing
ON
Flashing
ON
ON
VOLT
ON
AMPS
ON
DESCRIPTION
Run Command Source is from the keypad (B000=0)
(factory default)
Run Command Source is from external terminal (B000=1), or
RS485 communication control (B000=2)
Frequency Command Source is from the keypad (B004=0)
(factory default)
Frequency Command Source is from potentiometer on
keypad (B004=1), external analog signal (B004=2), up / down
frequency control using MFIT (S1-S6) (B004=3) or RS485
communication control (B004=4)
Drive is running in the forward direction
Drive is in the stop mode
Drive is running in the reverse direction
Drive is in the stop mode
Entering A or b parameters
Display is showing output frequency
Display is showing motor voltage (B014=1), DC bus voltage
(B015=1) or PID feedback voltage (B016=1)
Display is showing motor current (B013=1)
*Note – On initial powerup (factory default), the only LEDs that are on are Hz/RPM and FWD.
Motortronics
Keypad Functions & Navigation; Key Functions
23