Download Chapter B: user manual

TALREN 4
B - User manual
6.3. Data for stages and situations
This option is only available in the “Stages/Calculation” mode.
The printed document summarises all data and assumptions defined for the printed stage
and situation:
• Data for the stage:
o Hydraulic conditions;
o Active slope boundary;
o List of active loads;
o List of active reinforcements;
• Data for the situation:
o Calculation method;
o Partial safety factors;
o Seismic conditions;
o Description of the failure surfaces;
o Summarised results are also printed if available: minimum safety factor and
description of the critical failure surface.
6.4. Detailed results
6.4.1. Detailed results for failure surfaces
This option is available only in the "Stages/Calculations" mode, if results are available.
The printed document includes the same table as in the corresponding dialogue box (section
5.3.4).
6.4.2. Results relative to reinforcements
This option is available only in the "Stages/Calculations" mode, if results are available.
The printed document includes the same table as in the corresponding dialogue box (section
5.3.5).
6.4.3. Results detailed by slices
This option is available only in the "Stages/Calculations" mode, if results are available.
The printed document includes the same table as in the corresponding dialogue box (section
5.3.6): the printed table is the one corresponding to the critical failure surface.
Copyright TALREN 4 - TERRASOL – February 2005
Page 108