Download USER MANUAL

MV SWING LID SERIES USER MANUAL
VACUUM PUMP
Check before starting the machine if there is oil in the pump (see page 22). NEVER start the machine without oil in
the pump.
Use the right type of oil for the pump (see page 23).
After moving and/or transporting the machine, always first check the oil level before re-starting operation.
When starting the machine for the first time or after a lengthy idle period, first run the conditioning program before
operating the machine (see page 21).
CONNECTING THE GAS FLUSH SYSTEM (if applicable)
NEVER use flammable gasses or gas mixtures containing too much oxygen. There is a danger of explosion when
using the aforementioned gasses. Accidents and/or damage caused by using abovementioned gasses void all
liability on the part of Supplier as well as the guarantee.
The gas bottles must always be correctly secured. If the gas flush function and/or the machine is not in use then the
main cock of the gas bottle must always be closed.
The pressure of the pressure reducing valve on the gas bottle may NEVER be set to more than 15 Psi.
15 Psi. Is app. equal to 1 atmosphere/ATO.
A higher pressure may damage the machine.
The diameter of the hose nipple connector for the gas is for all machines (MV 250, 275, 285 and 295) 0,51 inch
(13 mm) The connector is at the rear of the machine.
For more information about the use of gas bottles, consult an authorised gas supplier
CONNECTING COMPRESSED AIR FOR EXTERNAL SEALING PRESSURE (if applicable)
The pressure from the compressor may NEVER be set to more than 15 Psi . A higher pressure may damage the
machine.
Only dry compressed air may be used for the external seal pressure.
The diameter of the hose nipple connector the compressor is 0,23 inch (6 mm’ (rear side of the machine)
For more information about the use of compressed air, consult an authorised gas supplier
Versie 06.02 DIG.EN
6