Download LodeStar User`s Guide - Oracle Documentation

Establishing Directories for Sequencer-Related Files
parameters are any parameters required by the program. To reference the output
directory (OUTDIR), you can use the ‘%JOBDIR%’ variable.
Note: The parameters file used by the PPM command will override the parameters in the
PGM command.
e.
Specify a file name for the output file using the OUT1 command. The format for this
command is:
OUT1 <filename>
where:
OUT1 is the keyword for the command
filename is the name of the output file. Note that you cannot specify a path using this
command.
This command controls the name of the output file for the following programs
f.
Program
Output File affected
Key Generator
Output Keys File
Copy Cuts
Keys List file
Prod / Direct Input
Keys List file (TGX112.DAT)
Validation
Edit Keys File
Invalid Series Validation
Editor Keys List
Editor Syntax Scan
Valid requests (TGX322.DAT)
Billed Energy
Analysis Control File (TGY231)
Cust Data Extraction
Keys List File (TGY247)
MPU Analysis
ICS File (TGY318)
Ratio Analysis
ICS File (TGY338)
Domains MPU Analysis
ICS File (TGY358)
Domains Ratio Analysis
ICS File (TGY368)
Individual Cust Analysis
DLM File (TGY377)
100% Sample Analysis
ICS File (TGY388)
Direct Output
Extracted Data File
If desired, you can include a Return Code Command in the Step Definition that specifies
a threshold for aborting the job stream.
The format is:
STP <n>
where:
STP is the required keyword for the command (enter as shown).
n is the maximum allowable return code. If the return code from the program equals or
exceeds n, the job will abort at that step. The default is 99. A list of return codes and
their meanings is provided in the last section of this chapter.
The Program Sequencer 6-11