Download user manual

07.4 Shutdown, storage and transport
Putting out of operation and storage
Clean and disinfect seca CT 320/321 and its components before putting
it out of operation.
Make sure that the storage location is dust-free, dry and away from direct
sunlight.
After a long period of non-operation, seca CT 320/321 may only be used
again if a technical safety check has been carried out by your authorised
seca dealer.
Transport
Clean and disinfect seca CT 320/321 and its components
before transport.
Use the original packaging for transport. This is a sensitive piece of electronic equipment.
If the original packaging is not available, pack the device in a way that it is
protected against collision, humidity and dust.
The device must comply with the operating conditions when it is put into
operation again, e.g. operating temperature (see 07.1 Technical Data...).
Ambient conditions for storage and transport
Temperature:
Air humidity:
Air pressure:
-20° ... +45°C
25 ... 95% rH
700 ... 1060 hPa
07.5 Disposal
The device and all its components must be disposed of in a proper manner in
compliance with applicable regulations (that is, in accordance with the
valid laws governing electrical and electronic waste). The device must not
be disposed of as normal domestic waste.
The original packaging is recyclable
(cardboard/waste paper).
51