Download User Manual

User Manual
- Choose the model to start from between the examples proposed in C:\Shape3dmodels.
- Enter the name of the model you are going to design, and your name as a shaper. Add any comments you
want.
- Choose the dimensions unit: centimeters, millimeters, inches or fractional inches.
- Check “Constrain proportions” if you want to keep the same ratio Length/Width/Thickness/Rocker… as the
starting model.
- Check the box “Stringer measurement” if these dimensions are measured along the stringer. Uncheck it if
they are measured along a straight line.
- Check the box “Symmetric nose/tail” for a twin-tip board.
- Input length, width, thickness, and tail/nose rocker.
- You can set the thickness of the sandwich if the board is designed to be built with the sandwich
technology.
- Press “Measurement wizard” if you want to input some measurements.
- Press OK.