Download DAC-SDI

DAC-SDI
2
Rev. 1
Quick Start Guides for DAC-SDI
2.1
Without GYDA controller
1. Attach SDI-IN and Black&Burst signals, and those output signals that you require, to the
backplane module (see figure 2 on page 9).
2. Set DIP-switch 1 on (towards backplane), switches 2 and 3 according to the video mode you
want (see figure 4 on page 15). Set switch 7 on for PAL, leave off for NTSC. Leave the rest
of the switches untouched.
3. Insert DAC-SDI into a slot in the sub-rack.
4. Power on. All LED’s should be green, and all outputs active. If this is not the case, please
see chapter 7.
2.2
With GYDA controller
1. Attach SDI-IN and Black&Burst signals, and those output signals that you require, to the
backplane module (see figure 2 on page 9).
2. Set switch 7 on for PAL, leave off for NTSC. Leave the rest of the switches untouched.
3. Insert DAC-SDI into a slot in the sub-rack.
4. Power on. All LED’s should be green, and all outputs active with the same settings as the
previous time power was applied.
5. Communication with the card is described in section 10.
Network Electronics ASA, P. O. Box 1020, N–3204 Sandefjord, Norway. Tel.: +47 33 48 99 99 — Fax: +47 33 48 99 98
E-mail: [email protected] — Web: http://www.network-electronics.com/
Technical specifications are subject to be changed without notice.
3