Download Electrical - ShipConstructor Software Inc.

Electrical Modeling
Figure 57: Cable edit section specified
You are now ready to edit the cable path. From here you can pick up the process from the section Specify Waypoints
above for creating cables. Aside from the fact that you’re only working on a section of the cable, the process is the same.
Editing a Broken Cable
The process for editing a broken cable is the same as for editing an intact cable however there is one restriction when
specifying the section of cable to edit.
Figure 58 shows a path for a broken cable. You can see that the point where the cable has been broken is marked by a
row explicitly indicating the break.
When you edit a broken cable, the edit range must include all <Break> rows. You will not be able to set the start or end
between any breaks.
60