Download USER`S MANUAL

With “Poly Mod” you can modulate the frequency and the pulse width of oscillator A as
well as the cut-off frequency of the filter. This allows you to create metallic sounds,
similar to bell sounds, or very particular special effects (notably by modulating the cutoff frequency of oscillator B).
Notice! If you use oscillator B as a modulation source, you can apply a modulation in which the speed will be
proportional to the note played on the keyboard. This gives you some interesting effects when oscillator B will
be used in the lower frequencies (LO FREQ).
SOURCE
AMOUNT
DESTINATION
Setting for the modulation rate of:

The filter envelope(“FILT ENV”)

Oscillator B (“OSC B”)
Selection buttons for modulation destinations:

Frequency of oscillator A (“FREQ A”)

Squared width of oscillator A (“PW A”)

Cut-off filter frequency (“FILTER”)
The FM polyphonic modulation section
5.1.9 Section modes for the keyboard
This section allows you to:

To deactivate the note release (“RELEASE”). When a key on the keyboard is
released, the sound is immediately interrupted and does not follow the release
phase that is programmed.

To release the hold continuing the note (“HOLD”). Even when the key on the
keyboard is released, the sound is maintained.

To activate the “LEGATO” playing mode. In this case, the envelopes are not
released when you link two notes by playing them on your keyboard.

To activate and set the “GLIDE” mode. This permits you to progressively change
the oscillator frequency when a new note is activated. This function imitates the
glissando of violins, for example.
RELEASE
Connection button for the release
HOLD
Connection button for holding a note
LEGATO
Connection button for
monophonic mode).
B RANGE
Set the range of the pitch bend wheel
GLIDE
Setting for the glide time
Glide Modes
The various modes for the glide (“OFF/ ON/ LEGATO”)
60
the
ARTURIA – Prophet-V – USER’S MANUAL
Legato
mode
(uniquely
available
in