Download FP0 User`s Manual

FP0
Specifications
12.7
Error Codes
RAM error 1
E22
RAM error 2
E23
RAM error 3 Stops
p
Probably an abnormality in the internal
RAM.
E24
RAM error 4
Please contact your dealer.
E25
RAM error 5
Please contact your dealer.
FP3
E21
Probably a hardware abnormality.
FP10SH
Stops
FP2SH
CPU error
FP2
E20
FP1/FP- M
Operation
Description and steps to take
status
FPΣ
Name
FP- e
Error
code
FP0
J Table of Self-Diagnostic Error
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
FP - e, FP0, FPΣ, and FP1 C14, C16:
Probably a hardware abnormality.
Please contact your dealer.
FP1 C24, C40, C56, C72, and FP - M:
Probably an abnormality in the memory
unit
E26
User’s
ROM error
Stops
.Program the memory unit again and
try to operate. If the same error is detected, try to operate with another
memory unit.
A
A
A
A
FP2, FP2SH, FP10SH, and FP3:
There may be a problem with the installed
ROM.
- ROM is not installed.
- ROM contents are damaged
- Program size stored on the ROM is
larger than the capacity of the ROM
Check the contents of the ROM
E27
Unit installation error
E28
System
register
error
Stops
E29
Configuration parameter error
Stops
E30
E31
Interrupt
error 0
Interrupt
error 1
Stops
Stops
Stops
Units installed exceed the limitations
(i.e., 4 or more link units)
A
Turn off the power and re-configure
units referring to the hardware manual.
Probably an abnormality in the system
register.
A
Check the system register setting or
initialize the system registers.
A parameter error was detected in the
MEWNET - W2 configuration area. Set a
correct parameter.
A
A
A
Probably a hardware abnormality.
A
Please contact your dealer.
An interrupt occurred without an interrupt
request.
A hardware problem or error due to noise
is possible.
A
A
A
A
A
A
A
A
Turn off the power and check the noise
conditions.
A: Available
12 - 43