Download Emulex Driver for Linux Version 8.2.0.48.2p User Manual

elx_mes0710: Iodone <target>/<lun>cmd <cmd> error <result> SNS <lp> <lp3>
DESCRIPTION: This error indicates that the Fibre Channel driver is returning a SCSI command to the
SCSI layer in error or with sense data.
DATA: (1) retry (2) resid
SEVERITY: Information
LOG: LOG_FCP verbose
ACTION: None required.
elx_mes0711: detected queue full - lun queue depth adjusted to%d
DESCRIPTION: The driver detected a queue full status on a scsi command response. New lun queue
depth is reported.
DATA: (1) New lun queue depth
SEVERITY: Warning
LOG: LOG_FCP verbose
ACTION: This may indicate an oversubscribed target array. Check your SAN configuration and IO
workload.
elx_mes0714: SCSI layer issued bus reset
DESCRIPTION: The SCSI layer is requesting the driver to abort all I/Os to all targets on this HBA.
DATA: (1) ret
SEVERITY: Error
LOG: Always
ACTION: Check the state of the targets in question.
elx_mes0715 - Bus Reset I/O flush failure: cnt <cnt> left <index>
DESCRIPTION: Timed out while waiting during a bus reset.
DATA: none
SEVERITY: Information
LOG: LOG_FCP verbose
ACTION: If other errors are also occurring, report this message to Technical Support.
elx_mes0716: FCP read underrun, expected <len>, residual <resid>
DESCRIPTION: An FCP device provided less data than was requested.
DATA: (1) fcpi_parm (2) cmnd[0] (3) underflow
SEVERITY: Information
LOG: LOG_FCP verbose
ACTION: None required.
elx_mes0717: FCP command <cmd> residual underrun converted to error
DESCRIPTION: The driver converted this underrun condition to an error based on the underflow field in
the SCSI command.
DATA: (1) len (2) resid (3) underflow
SEVERITY: Information
LOG: LOG_FCP verbose
ACTION: None required.
Driver for Linux - Troubleshooting Section
Page 51