Download "user manual"

3.4.3 Connecting Pan/Tilt/Zoom Devices
The Network Camera allows the connection of a Pan/Tilt/Zoom device into the camera.
The RS485 (+) and RS485(-) may be used for connecting such devices.
The supported protocol is Pelco D and Pelco P.
Refer to Chapter 5) Configuring the Camera, Camera Settings for more references on setting and
controlling the device by the Web user interface.
3.5
Power-over-Ethernet supported Network Cameras
The Network Camera comes as an optional model which supports Power-over-Ethernet (PoE).
Using Power-over-Ethernet as power supplying mode, takes advantage of having a simple connection, with
only one Ethernet Cable to act like Data and Power transmission. And it is not necessary to use any Power
Adapter since the powering will be done directly through the Ethernet Connector.
Below a comparison between a Regular Ethernet connection and a connection using Network Camera with
built-in Power-over-Ethernet.
Note: For safety precautions, when using a PoE Video Encoder, ensure that the standard Power
Connector has been Deleted before plugging the Ethernet cable (which is attached on the other end to a
PoE Hub / Switch).
Non-POE Connection
Power Adapter
Power Adapter
Ethernet cable
Ethernet cable
Ethernet cable
ADSL Modem
Broadband Router
Hub / Switch
Network Camera
Power Adapter
POE Switch & POE Network Camera
Power Adapter
Ethernet cable
Network Camera with
Power-over-Ethernet
Power Adapter
Ethernet cable
POE
Switch
Broadband Router
-9-
Ethernet cable
ADSL Modem