Download Operations Manual

CHAPTER 4 – USE
4.1 Conditions of use
4.1.1
Movement zone and position of the operator
x The operator’s working zone is located within the two vertical limits defined by the UIC 505-1 clearance gauge (Cf. §2.5 “Machine location in the
clearance gauge”) >> Photo n°1.
x During work, the operator must always be in the position shown on photo n°2 with his right hand firmly grasping the control handle and his left hand
holding the handle of the tilt wheel. This working position ensures full control of the machine.
If the operator is in the working position described above, it is impossible for him to move outside the two vertical limits defined by the UIC 505-1
clearance gauge.
Photo 2
Photo 1
MOVEMENT ZONE OF
THE OPERATOR
OPERATOR'S POSITION