Download USER REFERENCE MANUAL SGX NITRO

INSTRUMENT & SGX NITRO into a GUITAR AMP
Plug your instrument into the Left Input jack located on the rear panel. Connect a cable from your
instrument amp input to the Left Output jack. Turn the SGX NITRO on first and then turn on
your guitar amp. TURN DOWN THE LEVEL OF YOUR AMP before you play! Adjust your
levels accordingly. If you are clipping your amp, back off on the Output Level of the SGX
NITRO with the Output slider.
INSTRUMENT & POWER AMP
Plug your instrument into the either Input jack. Connect a cable from your power amp to either
Output jack. If your power amp is stereo, connect the left and right inputs of the amp to the Left
and Right Output jacks. Turn the SGX NITRO on first and then your power amp. Adjust the level
with the Output Level control.
INSTRUMENT & SGX NITRO in the EFFECTS LOOP of an AMP
Plug your instrument into your amp as normal. Connect a cable from the SGX NITRO's Left
Input to the amplifiers effect send. Now connect another cable from the effects return of your amp
to the Left Output of the NITRO. Turn the SGX NITRO on first then turn on your power amp.
Don't forget to change the operating level of your NITRO. The Level should be set to "Line". See
the Programmable Input description in the UTILITIES section. Adjust your playing level while
the effects loop is out of the chain. Engage the effects loop and set the input level to the NITRO
with the Input slider so the green LED is lit all the time (with signal present of course). Adjust
your output level with the Output slider.
SWITCHING BANKS
To switch between presets in a bank, be sure the PRESET LED is lit. If it isn't, press the Preset
button. Now use the Encoder to select the preset you wish. The preset number will be displayed
by the seven segment display. You may also select presets by entering the preset with the
alphanumeric keypad.
To switch banks, press the Edit Mode button, now press the Utility button. This puts you into
utility mode. One of the utilities is switching banks, turn the Encoder until you see:
"CLASSIC"
BANK =
"PERFORMANCE"
A
or
BANK =
"PRODUCTION"
B
or
BANK =
"CONTRIBUTION"
C
or
BANK =
D
The name of the bank is on the top and the bank designation letter is on the bottom. Now press
the value button and turn the Encoder until you see the bank you wish to access. Press the Preset
button to return to preset select mode and use the encoder to select presets. You will notice the
bank indicator letter as the last character in the title bar. After you first switch between banks, the
last preset you used will still be displayed in the LCD. This is normal, just turn the Encoder or use
the keypad to select your next preset.
5