Download M-230 Linear Actuators
Transcript
5 Installation 5.4 Installing the Actuator in a Mechanical Mounting NOTICE Incorrect tightening torque of the mounting nut! The motion of the pusher can be hindered by a mounting nut that has been tightened too strongly. This reduces the positioning accuracy. Tighten the mounting nut to a maximum torque of 1.7 Nm. INFORMATION To achieve an optimum repeatability, the mounting shaft must not have any backlash. During mounting, make sure that there is a faultless connection between the actuator and the mechanical mounting. Figure 7: Clamp connection (schematic) M-230 Linear Actuators 1 Mechanical mounting 2 Sleeve 3 Mounting nut, 3/8 inch 4 Mounting shaft with thread 5 Pusher with end piece (flat) MP102E Version: 1.1.0 23