Download Pulsar2 - Teleskop
Transcript
GENERAL Pulsar2 is a universal drive controller that can be user programmed for a wide range of mounts fitted with servo or bipolar stepper motors. It will work with motors only (steppers) or motors + incremental encoders. The unit is LX200 and ASCOM compatible, thus you can use it with your favourite Planetarium Program (Cartedu Ciel, Guide, Desktop Universe,The Sky, etc) and other sw like PemPro, CCD Autopilot, etc.. Pulsar will work as a standalone driver using the hand controller or connected to a PC (no hand controller is needed). If connected to a PC Pulsar2 can be reached through the ASCOM platform or by setting the mount type to LX200 (non GPS) or via the Pulsar Commander (download from www.astronomy.hu/pulsar2.html) and the LAN based virtual hand controller. To start using Pulsar2, connect the hand controller, mount and power. There is no power switch, you will either unplug power or send the mount to parking and leave it powered until next use. PEC on Pulsar2 will only work if the dedicated encoder is fitted to the RA worm. QUICKSTART Hand Controller Menu navigation Use the keypad to reach the menus. The North and South push of the Joystick navigates the menu up and down, the West push is Enter (yes), the East is Esc (no). The button CE also has the Esc function. Icons give a clue to the menus. The controller has a multi level menu structure but most important functions are directly accessed by pressing a button (see “KEY TO THE ICONS OF THE KEYBOARD” for more info). Information on the Display