Download Intermec Gateway User`s Guide

Transcript
Chapter 2 — Using the Intermec Gateway in the Native Environment
Enter Unit
Number:
42
Native
Unit # 42
Enter Host Name
MYHOST
You may still need to configure your devices to communicate
with the WTP network and access points. For help, see your
device user’s manual and your access point user’s manual.
Starting the Native Applications
After you have loaded the dcBrowser client, configured your
devices, and started your Intermec Gateway, you can run the
Native application on a UDP Plus or WTP device.
Trakker Antares UDP Plus Terminals
You can start the native application on your Trakker Antares
UDP Plus terminals by scanning a bar code or by using the
menu system.
To start Native applications on Trakker Antares UDP Plus terminals
• Scan this bar code:
Run Program C:DCBT24.BIN
*/O/OC/ZDCBT24/NBIN*
*//C:DCBT24.BIN*
Or,
1 On your terminal, access the TRAKKER Antares 2400 Menu
System by pressing ) y 2 4 8 or by scanning this
bar code:
Enter Test and Service Mode
*..-.*
*..-.*
Intermec Gateway User’s Guide
37