Download USER MANUAL

IT7300 User Manual
Volt-Max
Freq-Min
Freq-Max
Irms-Protect
BNC-Set
Voltage upper limit
Volt-Max=300.0V
Frequency lower limit
Freq-Min=45.0Hz
Frequency upper limit
Freq-Max=500.0Hz
Current RMS protect point
Irms-Protect=12.000A
BNC PORT SETUP
I-Trigger
I-On
O-Sync
O-On
Ipeak-Prote
ct
Input interface for external trigger
Input interface for on/off control
Output interface for AC phase synchronization
signal
Output interface for on/off state interface
LeadingEdge Phase dimmer function
LIST START MODE
On/off
Trigger
A-Phase/
C-Phase
B-Phase
/
3ø-Setup
Disable/Enable
Info
Set current RMS protect point
Set Current peak protect point
Phase dimmer
LeadingEdge
TrailingEdge
Off
List-Set
Set frequency upper limit
Current peak protect point
Ipeak-Protect=12.000A
DIMMER
Dimmer
Set Max, voltage
PRODUCT
Power information
INFO:
ERROR
INFO:
PRODUCT
INFO:
IT7321
Ver:0.01~0.0
1
TrailingEdge Phase dimmer function
Disable Phase dimmer function
LIST mode is used to simulate the power line
disturbance.
Enable List function
Press Shift+Enter(Trigger)to give a trigger signal
Configure phase line of each unit.(IT7321 do
not support this function.)
Turn on or turn off three-phase output function.
To achieve this function,user need to combine
three units.
For look up error information
Instrument type/Firmware version
5.9.2 Menu function
1. System menu
Initialize the system menu
relative factory default setup as follows:
Power-On
Sav0
29
User Manual