Download Telair Generators

Transcript
GB
Always fit a 100 A fuse
onto the positive cable connecting the generating set to the positive pole of the battery.
4.5 Electric Load connection
To connect loads to the power generating set,
use a three-pole cable up to the applicable standards in force. The correct cross section is
shown in Table 1.
Table 1
2
Model
Sect. mm
line 230 V
Cable leng.
Lgth < 6 m
Cable leng
Lgth. > 6 m
4010B
4
10
16
LINE
CONNECTION 230 V
BATTERY
CONNECTION
For connection to the 230V input line, the generating set is equipped with a special terminal strip
(Fig.13 Ref.1) to which the cables must be connected.
Vers. 002
Use the special cable outlet (Fig.11 Ref.1) to
prevent water seeping into the generating set.
Although the generating set is equipped with a
special internal thermal cut-out to cut power delivery in the event of overload or short circuits
(Fig.13 Ref.5), it is advisable to install (in the vehicle control panel) a thermomagnetic cut-out
switch, suitably set to stop power delivery to the
various users when current absorption exceeds
16,5 Amp.
If the generating set thermal cut-out switch has
been operated, press the button (Fig. 13 Ref. 5)
to restore closed circuit and power delivery conditions.
Carefully check the position of the line connection for picking up 230
Volt current. Wrong connection could damage the generating set irreparably or create
dangerous short circuits.
Energy 4010 B
11