Download "user manual"

7.
For an even more elegant solution, delete the two LH nodes by sub-selecting them (drag a box
around them), and clicking on the Del Node icon. Click on the remaining section of track
between the nodes to sub-select it and click on the To Arc icon. This will enable you to curve
the track neatly round the hole as shown below.
8.
To remove the nodes, click “off” the drawing (twice, if objects are sub-selected), or click on
End Edit. This will return the marquee box. Click off again to de-select.
N.B. All the same editing routines can be used on all types of drawing objects, lines, arcs, etc.
Page 20
DESIGN TOOLS - PCB Design & Make