Download Reference Manual

Error Messages
Error Messages
Error messages 10, 24, 50 and 53 are currently not used
ERROR 1: Memory allocation error in WSPG engine.
ERROR 2: Given channel for object [x] does not exist.
ERROR 3: Element [x] seems to end a streamline but is not a headwork.
ERROR 4: Node [x] is a headwork and has an upstream node.
ERROR 5: Node [x] is the system outlet and has a downstream node.
ERROR 6: Second system outlet [x] given. (Only one system outlet allowed.)
ERROR 7: Object [x] has more than one downstream element.
ERROR 8: Trying to connect the same element [x] to a join twice.
ERROR 9: Object [x] has more than one upstream element.
ERROR 10: Please use ascending order 1,2,3,... for channel numbers. This identifier is invalid: [x].
ERROR 11: Piers defined for channel [x] but average pier width data is missing.
ERROR 12: Point set [x] requested in channel section not found.
ERROR 13: Invalid number of piers (<0 or >10) for channel section [x].
ERROR 14: Not enough pier elevations given for channel [x].
ERROR 15: Channel cross section is changing at node [x]. Must replace node by a WALL-/ or BRIDGE-type node.
ERROR 16: Upstream and downstream channels change for reach [x]. Replace by a transition?"
ERROR 17: Headwork [x] has a higher elevation than its direct downstream node.
ERROR 18: Flow defined at headwork [x] is non-positive.
ERROR 19: Channel type for channel [x] is irregular! Types have to be between 1 and 6.
ERROR 20: Link [x] has non-positive length.
ERROR 21: Invalid curvature for closed channel [x]. Absolute value of curvature must be between 0 and 180 degrees.
ERROR 22: Invalid angle point for closed channel [x]. Angle point must be between 0 and 15 degrees.
49