Download Chapter 3 OPERATION USING THE KEYPAD

(*1) In speed monitor, you can have any of the following displayed according to the setting of function code E48: Output
frequency (Hz), Motor speed (r/min), Load shaft speed (r/min), and Speed (%).
(*2) Applicable only when PID control is active. (J01 = 1 or 2)
(*3) Applicable only when the analog signal input monitor is assigned to any terminals [12], [C1], or [V2] by E61, E62 or
E63 (= 20).
(*4) Applicable only when the full-menu mode is active. (E52 = 2)
Figure 3.2 Transition between Basic Display Frames by Operation Mode
3-3