Download Manual instruction - WLX, WTX balances

Or using the parameter: settings/ RS-232/Aut. printout/continuous
Frame format:
1
2
3
4
5
6
7-15
16
S
I
space
stability
space
sign
mass
space
Stability character
Sign
Mass
Unit
Command
17
18
unit
19
20
21
CR
LF
[space] if stable
[?] if not stable
[^] if an indication over the range
[v] if an indication below the range
[space] for positive values
[-] for negative values
9 characters justified to the right
3 characters justified to the left
3 characters justified to the left
Notice:
The frame length is constant (21 characters).
22.4.3. Continuous transmission „with pauses”
Continuous transmission „with pauses” allows users to determine the time
interval between the subsequent frames in the parameter interval. His type
of printouts can be enabled only in parameters: Settings/RS-232/ Aut.
printouts/with interv.
The frame format is the same as in basic simple transmission.
The interval is set in: Setting/RS-232/Interval
22.4.4. Stable result transmission
The scale automatically generates after each stable result separated by
a stable result below the Min. mass that can be set in parameters.
The intended use of this printout is for slip printers so it doesn’t have a
starting characters and the length can vary from 18 to 20 characters.
Standard length is 18 characters, but if the parameter digit marking has
been enabled, the length increases to 20 characters, because additional
brackets are printed e.g.:
- 58 -