1
Download TASKING VX-toolset for ARM User Guide
Transcript
TASKING VX-toolset for ARM User Guide Connecting the board 1. Connect any of the J-Link or ST-LINK debugger probes with the 20-pin JTAG/SWD cable to the board. Alternatively, you can use the ST-LINK/V2 that is embedded on the board. In this case, connect a USB cable from CN21 to a PC. 2. (Only if a debugger probe is connected) Connect J-Link or ST-LINK to a PC with a USB cable. 3. Power the board with the 5V DC power adapter connected to the power jack on the board. Eclipse target board debug configuration In order to debug in the Eclipse environment, you have to create a debug launch configuration for your hardware configuration. This is explained in Section 11.2, Creating a Customized Debug Configuration. Use the following settings: Target board debug configuration Setting Target STMicroelectronics STM320518-EVAL Configuration Default Connection J-Link over USB (JTAG or SWD) / ST-LINK over USB (JTAG or SWD) Flash settings: monitor file fstm32f051xx.sre Flash settings: sector buffer size 4096 Flash settings: workspace address 0x20000000 12.24. Using the STMicroelectronics STM32F0 Discovery The STM32F0 Discovery is an evaluation board for STMicroelectronics ARM Cortex-M0 core-based STM32F051R8 microcontrollers. Installing driver software Before you connect ST-LINK to the board or if you want to use the ST-LINK/V2 that is embedded on the board, first make sure you have installed the latest driver software. You can download the latest software for ST-LINK and ST-LINK/V2 from http://www.st.com/internet/com/SOFTWARE_RESOURCES/SW_COMPONENT/SW_DRIVER/st-link_v2_usbdriver.zip. 312
