Download 411829 Isolera User Manual

4
4.10.2 View, Print, and Save Reports on a USB Memory Device or the
Network
Two result reports are available for each purification: 1) an archive report with the selected
spectrogram from the mass analysis (if performed, only on Isolera Dalton System), purification
details, a chromatogram, a 3D absorbance spectrum for the whole detector range (requires an
Isolera Spektra license), and TLC data (if entered in the TLC to Step Gradient editor) and 2) a
fraction report. These reports can be printed to a network printer with postscript support or a local
USB printer and saved as PDF files on a USB memory device or in a share folder on your network.
1.
2.
Select the Results tab in the right-hand panel.
Select the desired record at the Result Selection tab. (If the record is not listed, see “Search
for Records” above.) An archive report for the selected record is available at the Archive
Report tab and a fraction report is available at the Fraction Report tab.
3. To view 2D and 3D absorbance spectra for the whole detector range (requires an Isolera
Spektra license):
a. Press λ... at the Report Setup tab. The Spectrum dialog opens.
b. To enable or disable UV baseline correction, press Correct Baseline. When enabled ( ),
the maximum solvent absorbance spectrum is subtracted from the signal presented by
the internal detector.
Drag this line to another position to show the absorbance spectrum at that time.
Drag one or both of these lines to other wavelengths to show the chromatogram at
those wavelengths.
Figure 4-23. 2D Absorbance Spectrum
411829-R, Operation
April 2015
Page 4-29