Download "user manual"

Transcript
CHAPTER 4 FUNCTIONS
Explanation
• When the mdBdModSet( ) function is executed and the mode of the board is changed temporarily,
the mode set in the utility is read instead of the currently operating mode.
• The following table shows the modes and the corresponding codes.
Description
Code
CC-Link IE Controller
CC-Link IE Field
CC-Link Ver.2
MELSECNET/H
Network
Network
0000H
Online(with automatic return)
Online(with automatic return)
Online
Online(normal mode)
0001H
—
—
—
Online(high-speed mode)
0002H
Offline
Offline
Offline
Offline
0003H
Data link test
Forward loop test
—
—
—
—
Station-to-station test
—
Loop test
Loop test
0004H
0005H
Remote station test
Reverse loop test
Setting parameter check
Station-to-station test
mode
(executing stations)
Station-to-station test
0006H
Hardware test
0007H
Not applicable
Self-loopback test
Self-loopback test
Self-loopback test
0008H
—
Self-loopback test (internal)
—
—
0009H
—
Hardware test
Hardware test
Hardware test
000EH
—
—
Bus interface test
Bus interface test
0010H
—
—
—
Memory test
(target stations)
4.3 Function Details
4.3.16 mdBdModRead (reading modes of board)
Return value
Success : Return the value 0.
Error
4
: Return the value other than 0. Refer to the list of error codes. ( Page 126, CHAPTER 6)
Related function
mdOpen(), mdClose(), mdBdModSet()
87