Download Installation Guide SNMP/Web Adapter

Transcript
Digital Energy
3.4
INTERFACES
3.4.1 UTP 10/100 – RJ45 port
Connection to Ethernet 10/100 Mbits/s networks, using a UTP cable.
3.4.2 RS-232 – RJ45 port
Serial communication, connection to a local console.
Use the serial cable provided with snmp/web adapter (RJ45 to DB9) for connection to a PC.
Connector pin-out as follows:
Pin #
Function
5
TD – Transmit Data
6
RD – Receive Data
4
GND
3.4.3 Contact interface – RJ11 port (1-ph plug-in version only)
Plug-in contact interface port.
Connector pin-out as follows:
Pin #
Function
1
Mains failure
4
On bypass / AVR**
2
General alarm *
5
N.C.
3
Battery low
6
GND
1
2
3
4
5
6
(*) Active if the output voltage of the UPS is no longer guaranteed due to other circumstances than
already indicated by pin 1-3-4.
(**) AVR (Automatic Voltage Regulation) function on line-interactive UPS only (e.g. Match Series)
Contact interface outputs are specified for the following ratings:
 IC max, closed
30mA
 VCE max, closed
0,4V [@1mA]
 VCE max, open
48V
CAUTION !
The RJ45 and RJ11 port share the same GND signal.
Exercise caution when both interfaces are used at the same time, particularly
when connecting these interfaces to non-floating ground systems.
Modifications reserved
GE_UPS_ISG_CNT_SNM_BAS_CRD_1GB_V020.docx
Page 18/25
Installation Guide SNMP/Web Adapter