Download Evaluation Kit User Manual

Transcript
Rev C - 02.1110
PLL & PLL with Integrated VCO Evaluation Kit User Manual
Figure 5. Typical PLL GUI (varies by PLL model)
5.9PLL Configuration Save/Load
To save a PLL configuration to a file, use the “Save Reg File” button in the bottom right corner of the “PLL
Main Control GUI”. This allows you to instantly recall the desired PLL state by using the “Load Reg File”.
Saving a “Register” file for PLL with Integrated RF VCO devices does not capture the “Mode” state (fo/2,
fo, 2fo).
Further instructions on the operation of the PLL with Integrated Microwave VCO products can be found in
the Evaluation Board Operating Guide available on www.hittite.com or on the CD-ROM.
Order On-Line: www.hittite.com. For technical application questions: Phone: 978-250-3343 or [email protected]
9